Novak Battery Power Connector (55-5750-1.2) Bedienungsanleitung PDF herunterladen

NOVAK POWER CONNECTORS

Low-Loss • Polarized • Gold-Plated

For best results, strip, twist, & pre-tin about 1/4” of your

16-12G power wires before soldering to the connector.

To avoid over-heating connector’s plastic, plug into a mating/opposite

end connector (not on a battery pack) to help dissipate extra heat.

Insert the stripped & tinned end of the wire into the correct barrel

of the connector

(“+” & “–” are marked on the side of connector)

. Heat

the tinned wire end with a good quality, high-power soldering iron

until the solder reﬂows into the connector’s barrel forming a clean

and continuous solder joint.

If needed,

add a small amount of extra

solder--again, being careful not to over-heat the connector’s plastic.

Slide the included heat shrink tubing over the wires and shrink over

the connector’s exposed barrel and the solder joint.

(949) 916-6044 • Monday-Thursday

www.teamnovak.com

NOVAK POWER CONNECTORSLow-Loss • Polarized • Gold-PlatedFor best results, strip, twist, & pre-tin about 1/4” of your 16-12G power wires before sol

Keine Kommentare

Novak Battery Power Connector (55-5750-1.2) Bedienungsanleitung